Tech Sheet

11
3. If they are correctly plugged in, replace the existing AM with a new one.
Reassemble all parts and panels and plug in the oven or reconnect
power. If the error code does not appear, follow the “Final Steps” section.
If the error code still appears, unplug oven or disconnect power and place
the original AM back into the oven.
4. Replace the existing HMI with a new one. Reassemble all parts and
panels and plug in oven or reconnect power. If the error code does not
appear, follow the “Final Steps” section. If it does appear, unplug oven or
disconnect power and place the original HMI back into the oven.
5. Replace the existing ADA expansion board with a new one. Reassemble
all parts and panels and plug in oven or reconnect power. If the error code
does not appear, follow the “Final Steps” section.
6. If the error code does appear, do not place the original expansion board
back into the oven.
7. Unplug oven or disconnect power. Replace the current AM with a new
one. Reassemble all parts and panels and plug in oven or reconnect
power. If the error code does not appear, follow the “Final Steps” section.
8. If it does appear, unplug oven or disconnect power and place the
original AM back into the oven. Replace the current HMI with a new one.
Reassemble all parts and panels and plug in oven or reconnect power. If
the error code does not appear, follow the “Final Steps” section.
9. If the error code does appear, do not place the original HMI back into the
oven.
10. Unplug oven or disconnect power. Replace the current AM with a new
one. Reassemble all parts and panels and plug in oven or reconnect
power. If the error code does not appear, follow the “Final Steps” section.
FAILURE ERROR LIKELY FAILURE CONDITION
F9 E0 Product not wired correctly
SUGGESTED CORRECTIVE ACTION PROCEDURE
1. Unplug oven or disconnect power. Check the wire connection from
the home power supply to the conduit according to the installation
instructions. Reassemble all parts and panels and plug in oven or
reconnect power. If the error code does not appear, follow the “Final
Steps” section.
2. If the error code does appear, unplug oven or disconnect power.
3. Check the wire connection from the conduit to the terminal block.
Reassemble all parts and panels and plug in oven or reconnect power. If
the error code does not appear, follow the “Final Steps” section.
4. If the error code does appear, unplug oven or disconnect power. Change
the AM control. Reassemble all parts and panels and plug in oven or
reconnect power. If the error code does not appear, follow the “Final
Steps” section.
5. If the error code does appear, unplug oven or disconnect power. Change
the main harness. Then reassemble all parts and panels and follow the
“Final Steps” section.