Tech Sheet

FAILURE ERROR LIKELY FAILURE CONDITION

Sensors

E0 Main oven sensor open or shorted

SUGGESTED CORRECTIVE ACTION PROCEDURE

NOTE: If the temperature is above 1112°F (600°C), the sensor is considered

open. If the temperature is below -4°F (-20°C), the sensor is considered short.

Be sure the oven is cold in both the cavity and electronic system.

1. Unplug oven or disconnect power. Check the sensor probe, cable, and

connector (J64 in microwave section, J62 in oven section.) Check the

whole board connection harness to see if anything is loose or damaged.

2. If they are loose, t the connectors in the proper place. Replace the

harness if damaged. If they are not loose, replace the sensor.

3. Reassemble all parts and panels. Plug in the oven or reconnect power.

Make sure the cavity is cold and start a forced air cycle and preheat to

212°F (100°C). Watch the progression bar to see if the temperature rises

regularly. If the temperature does rise correctly, follow the “Final Steps”

section.

4. If the temperature does not rise correctly, unplug oven or disconnect

power. Replace the new sensor with the original one and replace the AM

control board.

5. Reassemble all parts and panels. Plug in the oven or reconnect power

and start the cycle. If the error code does not appear, follow the “Final

Steps” section. If it does appear, unplug oven or disconnect power and

place the new sensor back in the oven and test it with the new AM control

board.

FAILURE ERROR LIKELY FAILURE CONDITION

F4 E1 Microwave cavity temperature sensor error

SUGGESTED CORRECTIVE ACTION PROCEDURE

NOTE: One minute after error code F6E1 appears, F3E0 will also show.

1. Unplug oven or disconnect power and check the sensor probe cable and

connector (J62). Check the whole board connection harness for any loose

or damaged connectors and t them in their proper place.

2. Replace the sensor of the harness if they are damaged. Reassemble

all parts and panels. If the error code does not appear, follow the “Final

Steps” section.

3. If nothing is loose or damaged, turn the power off. Turn back on after

10seconds and start a cooking cycle with the grill level on “High” power.