Flush Kit Installation Instructions

4
INSTALLATION INSTRUCTIONS
Prepare Built-In Microwave/Oven
Combination
NOTES:
■ Refer to the following “Installation Instructions” and
the “Installation Instructions” section of the Installation
Instructions provided with your built-in microwave/
oven combination.
■ Refer and adhere to the “Electrical Requirements” section
and complete the instructions in the “Make Electrical
Connection” section of the Installation Instructions provided
with your built-in microwave/oven combination.
1. Decide on the nal location for the oven. Avoid drilling or
cutting into house wiring during installation.
2. To avoid oor damage, set the oven on cardboard prior to
installation. Do not use the handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials that
may be needed for installation.
4. Remove the hardware package from inside the bag
containing literature.
5. Move oven and cardboard close to the oven’s nal location.
Remove Oven Door
IMPORTANT: Use two hands to remove the oven door.
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be at and covered with
a soft blanket, or use the corner posts from your packaging
material.
2. Fully open the oven door.
3. Locate the oven door hinge locks in both corners of the oven
door, and rotate the hinge locks toward the oven door to the
unlocked position. If the door hinge lock is not rotated fully
(see illustration B), the door will not remove properly.
A. Oven door hinge lock in
locked position
B. Oven door hinge lock in
partially unlocked position
4. Gently start to close the door. The door will stop at a partially
closed position.
5. Using two hands, grasp the edges of the oven door.
Close the oven door slightly past the stop position to take
the weight off of the door hinges, and then pull the oven door
up.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
Door
Hinges
Unlocked
position
position
Locked
to rotate
Grip here
06-May-2019 13:38:42 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")