Flush Kit Installation Instructions

6. Pull the oven door toward you and then remove. You may

need to gently shift door from side to side as you pull.

7. Set the oven door aside on the prepared covered work

surface with the oven door resting on its handle.

8. To continue with the oven installation, go to the “Positioning

Oven Feet” section.

Replace Oven Door

1. Using two hands, grasp the side edges of the door at the

midpoint. Face the oven cavity.

2. Locate the slots on each side of the oven cavity for the door

hinge locks.

3. Using two hands, grasp the edges of the oven door. At a 45°

angle, insert the hinges at the same time and push the oven

door into the oven cavity slot to replace. You may need to

gently shift the door from side to side as you push.

4. Make sure the door hinge notch is engaged on the bottom of

the oven cavity slot.

IMPORTANT: Do not close the door at this step or damage may

occur to the door hinge.

5. Lower the oven door to the fully open position. If the oven

door does not open to a full 90°, repeat steps 1 through 3.

6. Locate the oven door hinge locks in the corners of the oven

door, and rotate the hinge locks toward the oven cavity to

the locked position.

7. After the door hinges have been locked, gently swing the

door upward to close. The door should not be forced closed.

8. When the hinges are properly installed and the door is

closed, there should be an even gap between the door and

the control panel. If one side of the oven door is lower than

the other, the hinge on that side is not properly installed.

See “Remove Oven Door” and “Replace Oven Door.”

A. Slot in the oven cavity for door hinge lock

Unlocked

osition

Locked

position

06-May-2019 13:38:42 EDT | RELEASED

In some European factories the letter "W" of the part code mentioned herein will be automatically

replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")