Flush Kit Installation Instructions

Replace Plastic Spacers

1. Remove the 3 screws, 1 in each spacer, attaching the 3

plastic spacers (A) to the right side of the oven.

2. Using the 3 screws removed, install 3 new plastic spacers (B)

provided with this kit.

3. In the same manner, remove and replace the 3 plastic

spacers on the left side of the oven.

Install Oven

1. Using 2 or more people, lift the oven partially into the cabinet

cutout. Use the oven opening as an area to grip.

NOTE: When pushing the microwave oven into the cabinet,

open the microwave oven door and push against the seal

area on the front frame. Do not push against the outside

edges.

2. Push against the front frame of the microwave oven to push

oven into cabinet.

3. Push the microwave oven completely into the cabinet and

center the microwave oven into the cabinet cutout.

4. Remove the tape from the black front trims and remove the

zip tie from the mounting spacer.

■ Securely fasten the oven to the cabinet using the

#8-14 x 3/4" (1.9 cm) screws provided.

■ Insert the screws through hole in black trim aligning with

hole in oven frame and mounting spacer already in place.

A. Plastic spacer

B. New plastic spacer

A. Oven Frame

B. Mounting spacer

C. Oven frame hole

D. Black trim piece

06-May-2019 13:38:42 EDT | RELEASED

In some European factories the letter "W" of the part code mentioned herein will be automatically

replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")