Installation Instruction

INSTALLATION
INSTALLATION
INSTALLATION | 23
4
Install vent tube [5/16" I.D. x 32" (81 cm)] to
drain pump reservoir vent. Use one of the
supplied 5/8" small adjustable clamp.
7
Remove power cord clamp and ground
screw attached to ice maker power cord,
which is mounted to the unit side wall.
6
Route vent tube through plastic retainer
that is located underneath top deck in open
pump area as shown in the illustration.
Using cable tie, tie the vent tube to the
black suction tube which is located behind
the wiring cover. Secure wiring cover back
in place.
NOTE: Do not overtighten the vent tube, it
may block the airow through tube.
5
Unscrew the screws attaching wiring cover
to the ice maker. Remove wiring cover.
8
Slide drain pump into the ice maker base
on the right side. The pump mounting tab
should slip into the rectangular slot in the
ice maker base. It will be necessary to tip
the pump slightly to slip into the slot.
Drain
pump
Screws
Wiring
cover
Vent
tube
Vent
tube
Cable
tie
Plastic
retainer
Mounting
tab slot
Drain pump power cord,
clamp and screw
5/8" hose
clamp