User's Manual

[ Lint Filtering System (Automatic)
Ii Overl_ Protector I
The Lint Filtering system does not require cleaning.
A built-inprotectorautomaticallyshutsoffthe washermotorincaseof
Washand rinsewaterisfilteredand re-filteredcontinuouslytotraplint an overload_This canoccurif:
shed by most fabrics duringagitation cycle before it can be re-
depositedon thewashload. The engineered hole design on thewash • Too heavy a load is being washed.
basket in conjunction with water flow produced by the agitator traps
lint away from the clothes between the inner wash basket and outer • Too many appliances are plugged into the line operating
tub. Lint is automatically flushed from the washer during spin cycle, your washer.
• A low voltage condition exists on the line.
I Out of Balance Loads t • Lid is opened and closed repeatedly.
Your washer is designedto handle out of balance loads without The overloadprotectorpermitsthe washerto start again when the
shuttingdownor interruptingthewashingcycle. The cyclewillalways motorhas cooled toa safe operatingtemperature.
be completed,butclothesinthis cyclemay containexcessive mois-
ture. Redistributethe clothes in the washer and activate the washer If the motor stops repeatedly,call your Jenn-Air Service Contractor.
by selecting SPIN ONLY. Touch START/PAUSE Pad for extra spin.
I Safety Spin ]
The dispensermaybe usedforfabricsoftenerwith REGULARWASH
If for any reasonyou open the washer lid when the washer is in a cycles or liquiddetergentwith ULTRA WASH cycle The dispenser
SPINperiod, the operationwillimmediatelystop. IF YOUR WASHER should be cleaned after use of liquid detergent.
DOES NOT STOP, CALL YOUR JENN-AIR SERVICE CONTRAC-
TOR IMMEDIATELY. To clean the dispenser, hold the dispenser with bottom side up and
pushinward on the tabs. You are then able to clean both parts using
warm water and a brush if necessary.
LIQUID DISPENSER
_/,_I_NER CHAMeER
When the lid is closed the operation will automatically be resumed. _,-----OUTER CHAMBER
,//
To reassemble, hold both pieces in an upright position. Insert the
inner chamber into the outer chamber using ribs to position parts.
Rotate untila stop isfelt. Push parts together firmly to engage locking
tabs.
To turn light On or Off: The light switch is located under the control
panel on the left side. Push on the switch to turn the light on
and/or off.