Manual

4. Place the bottom tab of the blower box into the bottom 2. Lift up the blower box from the bottom mounting channel and

mounting channel, set aside.

A. Blower box

B. Bottom mounting channel

Tilt blower box top tab so it is flush with the vent box panel

and position it under the top mounting bracket. Slide bracket

into the "Z" slots and tighten the 2 hex/slotted head screws

to secure.

See "Complete Installation" section.

Rear Venting:

1. Remove the vent box. Loosen the 2 hex/slotted head screws

that attach the top bracket that secures the motor to the vent

box enough to slide the bracket into the "Z" slots. This will

move the bracket away from the top mounting lip of the

blower box and allow it to tilt away from the vent box panel.

A. Bracket with "Z" slots

B. Hex/slo tted head screws (2)

A. Blower box

B. Bottom mounting channel

Disconnect the wire connector from the blower motor.

A. Blower motor

B. Wire connector

4. Remove the 2 screws that mount the motor mounting bracket

to the vent box. Remove the blower motor and mounting

bracket assembly from the vent box.

........A

A. Blower motor mounting bracket screws (2)

5. Remove the 4 screws from the small cover plate on the rear

of the vent chamber and set screws and cover plate aside.