Dimensions Guide

JENN-AIR
®
DETAILED PLANNING DIMENSIONS
3 of 3
8550AdZw715
IMPORTANT: Dimensional specifications are provided for planning purposes only.
Do not make any cutouts based on this information. Refer to the Installation or Use & Care Guide
before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation.
All Jenn-Air
®
appliances are appropriately UL, CUL or CSA approved.
OPENING/CLEARANCE DIMENSIONS
A
G
H
I
†
J
B
D
C
E
D
C
F
A*
I
J
‡
K
L
F*
B*
C*
D*
E*
F
G
K
†
L
H
‡
G
MODEL #
JUD24FCERS
JUD24FCECX
in cm
A
Width (min.) 24 61.0
B
Height (min.) 34
3
⁄8 87.3
C
Height to utility access location 22 55.9
D
Depth to utility access location 1 2.5
E
Depth (min.) 24 61.0
F
Water line location – distance from side 3 7.6
G
Water line location – distance from bottom 14 35.6
u
Recommended utility access location
UNDER COUNTER REFRIGERATOR/FREEZER DRAWERS
JUD24FCERS – 23
7
⁄8" x 34
1
⁄8" x 26 (including handles)
JUD24FCECX – 23
7
⁄8" x 34
1
⁄8" x 23
7
⁄8"
Floor
Wall
B
A
E
u
C
D
BACK VIEW
FRONT VIEW
SIDE VIEW
Floor
Wall
B
A
E
u
C
D
ELECTRICAL REQUIREMENTS
115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded circuit is required.
A dedicated circuit is recommended. Use an outlet that cannot be turned off
by a switch. Minimum length of the power cord is 63" (160.0 cm). Do not use an
extension cord.
WATER PRESSURE REQUIREMENTS
A cold water supply with water pressure between 30 and 120 psi (207
and 827 kPa) is required to operate the ice maker. Call a licensed, qualified plumber
with any questions about the water pressure.
Reverse Osmosis Water Supply
IMPORTANT: The pressure of the water coming out of a reverse osmosis system
going to the water inlet valve of the refrigerator needs to be between 30 and 120
psi (207 and 827 kPa).
If a reverse osmosis water filtration system is connected to the cold water supply,
the water pressure to the reverse osmosis system needs to be a minimum of 40 to
60 psi (276 to 414 kPa).