software Manual

17
If the same sample needs to
be measured more than
once click on the Auto Log
button.
The instrument will perform
the required number of
readings with the specified
time interval between each
measurement as set in the
Settings screen.
The results will be displayed
on the screen. The batch
name entered in the settings
screen will have 01, 02 etc
after the name, to signify the
order in which the results
were generated.
Auto logging can be stopped before all the measurements have been completed by clicking on the
Stop button. To recommence auto logging click on the Auto Log button again.
If the settings menu is re-entered following sample measurement it is not possible to change the
wavelength. A new photometrics tab can be opened and the new wavelength can be entered.