software Manual

19
4.1 Settings
To set the measurement parameters click on the Settings button.
This screen allows the batch
name, wavelength, resolution,
concentration units, factor and
standard values and to be set. If
auto logging is required the
parameters can be set in this
screen. Comments can be
entered which will be included on
the result printouts.
Once the required measurement
parameters have been entered
click on the OK button to accept
and continue with calibration and sample measurement. To exit the settings without saving any
measurement parameters click on the Cancel button. To save the measurement parameters for future
use click on the Save button. To load previously saved measurement parameters click the Open
button. For more details on saving and opening method parameters refer to section 8.