software Manual

22
4.1.5 Entering a factor
To select the factor to be used type
the factor value into the text box.
Factor values of 0.001 to 10,000 can
be entered. If the value entered is
outside of the range an error icon will
be displayed and this must be
corrected before the settings screen
can be exited.
If the factor is not known the value
entered should be 1 and a standard
should be measured in order to
calculate the factor.
4.1.6 Entering a standard
To select the standard to be used put
a tick in the box adjacent to use
standard and type the standard value
into the text box. Standard values
from 0.001 to 1000 can be entered. If
the value entered is outside of the
range an error icon will be displayed
and this must be corrected before
the settings screen can be exited.
If the factor is known there is no
need to use a standard and the
standard value entered should be 1.