software Manual

5.1 Settings

To set the measurement parameters click on the Settings button.

This screen allows the sample

name, start and end wavelengths,

scan interval, resolution, and

operating mode to be set. If Auto

Logging is required the

parameters can be set in this

screen. Comments can be

entered which will be included on

the result printouts.

Once the required measurement

parameters have been entered

click on the OK button to accept

and continue with calibration and

sample measurement. To exit the settings without saving any measurement parameters click on the

Cancel button. To save the measurement parameters for future use click on the Save button. To load

previously saved measurement parameters click the Open button. For more details on saving and

opening method parameters refer to section 8.