software Manual

51
7.1 Settings
To set the measurement parameters click on the Settings button.
This screen allows the sample name, wavelength, kinetics run time, time interval, concentration units
and resolution, operating mode, lag time, start on level to be set. If auto logging is required the
parameters can be set in this screen. Comments can be entered which will be included on the result
printouts. The standard curve can also be viewed by clicking the Show Curve button.
Once the required measurement parameters have been entered click on the OK button to accept and
continue with calibration and sample measurement. To exit the settings without saving any
measurement parameters click on the Cancel button. To save the measurement parameters for future
use click on the Save button. To load previously saved measurement parameters click the Open
button. For more details on saving and opening method parameters refer to section 8.