software Manual

65
To open the control for the
accessory click on the Accessories
tab on the toolbar at the top of the
screen and click Sipper accessory.
To operate in manual mode click
the forwards or backwards button
depending on the required sample
flow direction. Click on the stop
button to stop the sipper pump.
When the flow-through cuvette is
full click Close as a sample
measurement cannot be performed
when the accessory control is
open.
To operate in timed mode click on
the Edit programs button.
This screen enables the sample
take up time, air gap and sample
disposal to be programmed.
Program 1 is for the sample take
up time. Type the required time in
seconds in the text box or use the
arrow keys. The pump direction
can be reversed by putting a tick in
the box adjacent to reverse
direction.
Program 2 is for the air gap time.
Type the required time in seconds
in the text box or use the arrow
keys. The pump direction can be
reversed by putting a tick in the
box adjacent to reverse direction.
Program 3 is for the sample disposal. The sample can be either be sent to waste or back to the
sample container. Type the required time in seconds in the text box or use the arrow keys. If the