software Manual

66
pump direction is reversed by putting a tick in the box adjacent to reverse direction this will send the
sample back to the sample container.
When the required settings have been entered click on OK to save. Click on Cancel to return to the
sipper pump accessory screen without saving any of the settings.
In the Pre-Programmed section clicking on
the sample button will make the instrument
follow the parameters set under program 1.
Clicking on the air button will make the
instrument follow the parameters set under
program 2. Clicking on the waste button
will make the instrument follow the
parameters set under program 3. To stop
any of these actions click on the stop
button.
To exit the sipper pump control click Close.
This control must be closed before
measurements can be performed.
12.3 Peltier
The peltier accessory is used to heat sample.
To open the control for the accessory
click on the Accessories tab on the
toolbar at the top of the screen and
click on the Peltier accessory.
Type the required set point into the
text box and click on Apply set point.
Depending on the current
temperature the peltier will begin
either heating or cooling.
The temperature units can be
changed by clicking in the circle
adjacent to Celsius or Fahrenheit.