Use and Care Manual

13
11.2 Blade and cutting problems
Symptom Possible Cause Correction
Rapid blade wear Feed speed too slow The blade runs over the material without
removing it: Increase pressure of blade into
workpiece.
Broken blade
Feed speed too high
Reduce pressure of blade into workpiece.
Blade in contact with material before
starting the cut
Make sure blade is clear of workpiece before
starting machine.
Cuts not straight
Feed speed too strong
Reduce feed speed.
Blade not perpendicular to workpiece.
Contact JET technical support.
Table 4
12.0 Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-
274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and Serial Number of
your machine available when you call will allow us to serve you quickly and accurately.
Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from JET.
Some parts are shown for reference only, and may not be available individually.