Use and Care Manual

17
Troubleshooting
Fault Probable Cause Suggested remedy
Excessive blade
breakage
1. Material loose in vise.
2. Incorrect speed or feed.
3. Teeth too coarse for material.
4. Incorrect blade tension.
5. Saw blade is in contact with work-
piece before the saw is started.
6. Misaligned guides.
7. Cracking at weld.
1. Clamp work securely.
2. Check Machinist’s Handbook for
speed/feed appropriate for the
material being cut.
3. Check Machinist’s Handbook for
recommended blade type.
4. Adjust blade tension to the point
where the blade just does not slip on
the wheel.
5. Start the motor before placing the
saw on the workpiece.
6. Adjust guides.
7. Longer annealing cycle.
Premature blade
dulling
1. Blade teeth too coarse.
2. Blade speed too high.
3. Inadequate feed pressure.
4. Hard spots in workpiece or scale
on/in workpiece.
5. Work hardening of material
(especially stainless steel).
6. Insufficient blade tension.
7. Operating saw without pressure on
workpiece.
1. Use a finer tooth blade.
2. Try a lower blade speed.
3. Decrease spring tension.
4. Increase feed pressure (hard spots).
Reduce speed, increase feed pres-
sure (Scale).
5. Increase feed pressure by reducing
spring tension.
6. Increase tension to proper level.
7. Do not run blade at idle in/on
material.
Bad cuts (crooked)
1. Workpiece not square with blade.
2. Feed pressure too fast.
3. Guide bearings not adjusted
properly.
4. Inadequate blade tension.
5. Span between the two blade guides
too wide.
6. Dull blade.
7. Incorrect blade speed.
8. Blade guide assembly is loose.
9. Blade guide bearing assembly loose.
10. Blade track too far away from wheel
flanges.
11. Guide bearing worn.
1. Adjust vise so it is square with the
blade. (Always clamp the workpiece
tightly in the vise.)
2. Decrease pressure.
3. Adjust guide bearing clearance to
0.001 inch (0.002 inch maximum).
4. Gradually increase blade tension.
5. Move blade guide bracket closer to
work.
6. Replace blade.
7. Check blade speed.
8. Tighten blade guide assembly.
9. Tighten blade guide bearing
assembly.
10. Adjust blade tracking.
11. Replace worn bearing.