Use and Care Manual

Troubleshooting (cont.)

Fault Probable Cause Suggested remedy

Bad cuts (rough)

1. Blade speed too high for feed

pressure.

2. Blade is too coarse.

1. Reduce blade speed and feed

pressure.

2. Replace with finer blade.

Blade is twisting

1. Blade is binding in the cut.

2. Blade tension too high

1. Decrease feed pressure.

2. Decrease tension on Blade

Unusual wear on

side/back of blade

1. Blade guides worn

2. Blade guide bearings not adjusted.

3. Blade guide bearing bracket is

loose.

1. Replace blade guides.

2. Adjust blade guide bearings.

3. Tighten blade guide bearing bracket.

Parts

Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call

1-800-274-6848 Monday through Friday, 8:00 a.m. to 5:00 p.m. CST. Having the Model Number and

Serial Number of your machine available when you call will allow us to serve you quickly and accurately.

Non-proprietary parts, such as fasteners, can be found at local hardware stores, or may be ordered from

JET. Some parts are shown for reference only, and may not be available individually.