Use and Care Manual

11
12.10 Angle adjustment
To swivel the saw arm up to a 45° angle:
1. Disconnect machine from power source.
2. Pull the handle (A, Figure 13) toward the front
of the saw.
3. Rotate the upper assembly to the desired
angle.
4. Push the handle back toward the rear of the
saw to lock the upper assembly.
Figure 13
To adjust the 90° stop:
1. Disconnect machine from power source.
2. Lower saw arm completely.
3. Pull the lock lever toward the front of the saw
and pull the saw arm assembly against the 90°
stop.
4. Place a 90° square on the blade and the fixed
vise jaw.
5. Loosen the lock nut (A, Figure 14).
6. Adjust the hex cap screw (B, Figure 14) until
the blade is at a 90° angle to the fixed vise
jaw.
7. Tighten the lock nut (A, Figure 14).
Figure 14
To adjust the 45° stop:
1. Disconnect machine from power source.
2. Lower saw arm completely.
3. Pull the lock lever toward the front of the saw
and push the saw arm assembly against the
45° stop.
4. Place a 45° angle square on the blade and the
fixed vise jaw.
5. Loosen the lock nut (A, Figure 15).
6. Adjust the hex cap screw (B, Figure 15) until
the blade is at a 90° angle to the fixed vise
jaw.
7. Tighten the lock nut (A, Figure 15).
Figure 15
12.11 Vise adjustment
To position the movable vise jaw:
1. Turn vise handwheel 1/2 turn counter
clockwise.
2. Move rack block (B, Figure 16) to desired
location by sliding along the bed. Place the
rack block onto the rack.
3. Turn the handwheel to tighten the vise.
Figure 16
To adjust the vise for angle cutting: