Use and Care Manual

7
IBGB-248VS IBGB-248 IBGB-436VS IBGB-436
Main materials
Grinder
Motor housing Sheet metal
End cover Aluminum (Grinder side) / Cast iron (Belt sander side)
Base Cast iron
Tool rest Cast iron
Inner wheel guard Cast iron
Outer wheel guard Aluminum
Flange washer Cast iron
Eye shield Polycarbonate
Sander
Belt table Cast iron
Belt table bracket Sheet metal
Tool rest Sheet metal
Tool rest bracket Sheet metal
1
subject to local and national electrical codes.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height, D = depth
OD = outside diameter
n/a = not applicable
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.
4.1 Mounting hole dimensions
Figure 4-1 Mounting dimensions, all models