Operating Instructions and Parts Manual SR-1650M Slip Roll JET 427 New Sanford Road LaVergne, Tennessee 37086 Ph.: 800-274-6848 www.jettools.com Part No.
Warranty and Service JET warrants every product it sells against manufacturers’ defects. If one of our tools needs service or repair, please contact Technical Service by calling 1-800-274-6846, 8AM to 5PM CST, Monday through Friday. Warranty Period The general warranty lasts for the time period specified in the literature included with your product or on the official JET branded website. • JET products carry a limited warranty which varies in duration based upon the product.
For your own safety, read the owner’s manual before operating the slip roll. This slip roll is designed and intended for use by properly trained and experienced personnel only. If you are not familiar with the proper and safe operation of a slip roll, do not use until proper training and knowledge has been obtained. 1. KEEP GUARDS IN PLACE and in working order. 2. KEEP ALL BODY PARTS AWAY FROM MOVING PARTS. Avoid placing any part of your body near belts, cutters, gears, etc. 3.
Specifications Stock Number................................................................................................................................ 756050 Model Number .......................................................................................................................... SR-1650M Capacity (mild steel) .............................................................................................................................. 16 Maximum Forming Length .............................
Releasing the Material Rolling Wires 1. Once material has been rolled, release it from roll by lifting clamp handle (Figure 3). There are three wire grooves in the upper and rear rolls that will accommodate a 1/4", 5/16” and a 3/8” wire. 2. Lift upper roll and pivot away from machine, so that material can be removed. Lubrication (Numbers in breakdown.) parentheses refer to parts The machine must be lubricated every day of service with a few drops of oil.
Breakdown for the SR-1650M Slip Roll 6
Parts List for the SR-1650M Slip Roll Index No. Part No. Description Size Quantity 1 ................ SR1650N-1G............. Base Assembly ........................................................ ...................................... 1 2 ................ SR1650N-2 ............... Hex Cap Screw ........................................................ M16x25 ......................... 4 3 ................ SR1650N-3 ............... Upper Roll ...............................................................
427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.