Installation Instructions

FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority
to operate the equipment. This equipment has been tested and found to comply with
the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful
interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures: ‐‐ Reorient or relocate the receiving antenna.
‐‐ Increase the separation between the equipment and receiver.
‐‐
Connect the equipment into an outlet on a circuit different from that to which the recei
ver is connected.
‐‐ Consult the dealer or an experienced radio/TV technician for help.
RFExposure:A
distanceof20 cmshallbemaintainedbetween
thea
ntennaandusers,andthetransmittermaynotbeco‐located
with
a
nyothertransmitterorantenna.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device
must accept any interference received, including
interference that may cause undesired ope ration.