Operation Manual

4.- Insert the thread through the small bobbin hole from the
inside and take out about 8 cm of thread.
5.- Hold the end of the thread tight and press the ON button or
the control pedal. Stop once it has gone around a few times.
6.- Cut the end of the thread with scissors in the top part of the
bobbin and then continue with the winding until the amount of
thread desired is wound.
7.- Cut the thread at about 8 cm from the bobbin. Extract the
thread bobbin from the spindle.
8.- Put away the spindle rewinder and put the long spindle in its
place.
NEEDLE CHANGE
1.- Lift up the needle to its maximum position by turning the
balance wheel with the presser foot in its lowest position.
2.- Hold it and release the screw that adjusts the needle. Remove
the needle.
3.- Put the new needle in the support with the flat part to the
side of the machine making sure that the needle eye is facing
the front of the machine. Do not try to push the needle upwards
whilst placing it in the support before adjusting the screw.
4.- Tight the needle adjustment screw.
CLEANING AND STORAGE
-For correct operation, the machine requires regular cleaning
and greasing.
IMPORTANT: Before cleaning, make sure the machine is
disconnected from the mains and that it does not have any
batteries inside.
-Use a cloth to clean the machine and remove any surplus oil.
-Do not use lubricants such as solvents, abrasive detergents or
products that may damage the machine.
-Use specific oil for sewing machines (any other type of oil could
damage it). Oil with one drop where there is friction.
-NEVER SUBMERGE THE MACHINE IN WATER OR IN ANY
OTHER LIQUID.
FREQUENT PROBLEMS
1. The top thread is not properly threaded.
2. The control pedal is not connected to its corresponding socket.
3. The needle is not correctly placed in its support.
4. The needle eye is not facing the front part of the machine.
5. The needle is bent.
6. The lower thread is not properly threaded or is broken.
7. An incorrect sized lower bobbin is being used.
8. The thread tension is not correct.
9. The lower bobbin and its support are not in the correct position,
so the support is blocked and does not turn clockwise.
TECHNICAL SPECIFICATIONS
6V DC (4xAA 1,5V)
This appliance conforms to the safety requirements and
provisions of directives 2006/95/EC on Low tension devices and
2004/108EC on Electromagnetic Compatibility.
PROTECTION OF THE ENVIROMENT – DIRECTIVE
2002/96/EC
This product has been designed and manufactured with high
quality materials and components that can be recycled and
reused.
When you see the symbol of a crossed out litter bin on
wheels next to a product, this means that the product
conforms to the European Directive 2002/96/EC.
Please obtain information about the local recycling system
for electric and electronic products.
Follow the local rules and do not dispose of used products by
throwing them in the normal bins at home. Proper recycling
of your used product will help avoid negative impacts on the
environment and people’s health.
EN-25
24-EN