Use and Care Manual
MXT015284—UN—29JUL15
11. On top side of deck, remove lock nut (M) from deector stud.
12. Release front tabs (N) from front deck bafe and remove left side
deector (O).
Storing MulchControl™
Clean and store all MulchControl™ parts in a clean, dry place.
OUMX068,0000D12-19-07MAR16
Troubleshooting
Using Troubleshooting Chart
If you are experiencing a problem that is not listed in this chart, see
your authorized dealer for service.
When you have checked all the possible causes listed and you are still
experiencing the problem, see your authorized dealer.
BS62576,00014F0-19-19SEP13
MulchControl™
IF Check
MulchControl™ gate will not
open
Plugging of mower deck/bafes.
MulchControl™ gate will not
close
Plugging of mower deck/bafes
MulchControl gate not holding
setting (open or closed)
Adjust system for proper spring
tension
MulchControl™ causing blowout
in closed position
Check that gate stop is installed
(after removal of cut and throw -
42 in. Accel Deep™ only)
Ensure that system is in closed
position
Adjust system for proper spring
tension
MulchControl™ Material
Dispersion Not Satisfactory
Clean debris buildup from
underside of deck
IF Check
Check blades for sharpness and
damage
Ensure that correct blades are
installed (MulchControl™ is
designed to use mulch blades,
not standard blades)
Change blades
Check discharge chute for
damage
Check procedures on Adjusting
Mower Level Side-to-Side and
Front-to-Rear.
Adjust system for proper door
position
Run engine at fast throttle
Mowing too fast for grass
conditions
OUMX068,0000D40-19-07MAR16
Troubleshooting
16