Installation Guide

Fluid System
Products
Our fluid system products are
simple to use without the need for
special tools. This is just one of
many reasons we are known for our
innovative solutions across diverse
industries.
Standard push-fit fittings, shut-off
valves and polyethylene tubing
are produced from FDA compliant
materials and are listed with NSF
International Standards 51 and 61.
Our push-fit fittings, shut-off
valves and polyethylene tubing
have been designed for use with
a wide range of industrial water
treatment applications, involving
water purification, reverse osmosis,
ice makers, beverage dispensing,
vending & OCS, car washing systems,
Marine/R. V. and many more.
The push-t people
How to make a
Push-Fit connection
To connect
Keep product clean until ready to use. Always pressure test once installed.
Cut the tube square and remove
any burrs or score marks. We
recommend using a tube insert
for so or thin-walled
plastic tubing.
Step 1
Push the tube into the tting and
up to the tube stop.
Step 2
Pull on the tube to check that
it is secure. Test the system
before use.
Step 3
To disconnect
Make sure that the system
is depressurized, then push
the collet square against the
fitting. With the collet held
in this position, the tube can
be removed.
Step 1
Stainless steel teeth
grip the pipe to hold its position
O-ring
provides leakproof seal
Collet
grips before it seals
11johnguestusa.com10 [e-mail]