JLDWS 1208 Dishwasher Instruction manual
Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
• The water in your dishwasher is not for drinking. Detergent residues may still be present in your machine. • Ensure that the door of the dishwasher is always closed when it is not being loaded or unloaded. In this way you will avoid anybody tripping over the open door and hurting themselves. • Do not sit or stand on the open door. • Keep all detergents in a safe place out of children’s reach. • Keep children well away from the dishwasher when the door is open.
• Automatic Wash Programme: This machine is fitted with a turbidity sensor which intelligently adjusts the temperature and rinsing cycles during the wash programme, depending on the degree of soiling on the dishes. This helps to reduce energy and water consumption on lightly soiled loads. The symbol on the product or on its packaging indicates that this product may not be treated as household waste.
Contents For the user For the installer Important safety information 2 Technical data 27 Description of the appliance 27 27 27 28 The control panel The digital display Function buttons (A, B, C, D and E) Audible signals Washing programmes Installation 6 Unpacking Fitting under a counter Levelling 7 8 8 8 Water connections Water inlet connection Water drain connection 9 When the dishwasher is first Electrical connection installed 10 The water softener 10 Repairs - After sales service Filling wi
Description of the appliance 1. 2. 3. 4. 5. Upper basket Water hardness dial Salt container Detergent dispenser Rinse aid dispenser 6. 7. 8. 9. 10.
The control panel D 1. 2. 3. 4. 5. 6. Digital display Delay start button Programme selection buttons Indicator lights On/Off button Function buttons Indicator lights Multi tab Indicates the activation/ deactivation of the Multi tab function (See 'Multi tab function'). 1) The salt and rinse aid indicator lights are never on while a washing programme is running even if filling with salt and/or rinse aid is necessary.
The digital display Always remember that when performing the following operations: • Selecting a washing programme, • Setting the water softener, • Activating/deactivating the rinse aid dispenser, • Activating/deactivating the audible signals, the appliance MUST be in setting mode.
3. Press function button C, the lights of function buttons A and B go off while the light of function button C continues to flash. The digital display shows the current setting. Audible signals activated 4. To change the setting, press again function button C. Each time the button is pressed the level changes, the digital display shows the new setting. 5. To memorize the operation, switch off the dishwasher by pressing the On/Off button.
Consumption values1) Programme Programme duration (in minutes)2) Energy consumption (in kWh) Water consumption (in litres) 70° Intensive - 1,4 - 1,6 16 - 18 Automatic - 1,1 - 1,7 12 - 23 - 1,0 - 1,1 12 - 13 Quick wash - 0,9 9 Rinse hold - 0,1 4 50° Economy3) 1) The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply and the amount of dishes.
Adjusting the water hardness setting Water hardness Use of salt Clarke °TH mmol/l manually electronically 64 - 88 91 - 125 9,1 - 12,5 2 level 10 yes 53 - 63 76 - 90 7,6 - 8,9 2 level 9 yes 46 - 52 65 - 75 6,5 - 7,5 2 level 8 yes 36 - 45 51 - 64 5,1 - 6,4 2 level 7 yes 28 - 35 40 - 50 4,0 - 5,0 2 level 6 yes 23 - 27 33 - 39 3,3 - 3,9 2 level 5 yes 18 - 22 26 - 32 2,6 - 3,2 1 level 4 yes 13 - 17 19 - 25 1,9 - 2,5 1 level 3 yes 5 - 12 7 - 18 0,7 - 1,8
3. Using the funnel provided, pour in the salt until the container is full. Examples: displayed, 5 intermittent audible signals, pause, etc. = level 5 displayed, 10 intermittent audible signals, pause, etc. = level 10 4. To change the level, press function button A. Each time the button is pressed the level changes. (For the selection of the new level see the chart).
The dispenser holds about 110 ml of rinse aid, which is sufficient for between 16 and 40 dishwashing cycles, depending upon the dosage setting. 3. Ensure that the lid is closed after every refill. Rinse aid ensures thorough rinsing, and spot and streak free drying. Rinse aid is automatically added during the last rinse. 1. Open the container by pressing the release button (A). Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.
Daily use • When loading the dishes and cutlery, please note: – Dishes and cutlery must not impede the rotation of the spray arms. – Load hollow items such as cups, glasses, pans, etc. with the opening downwards so that water cannot collect in the container or a deep base. – Dishes and items of cutlery must not lie inside one another or cover each other. – To avoid damage to glasses, they must not touch. – Lay small objects in the cutlery basket.
The lower basket The lower basket is designed to take saucepans, lids, plates, salad bowls, cutlery, etc. Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the spray arms can turn freely. The cutlery basket Warning! Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives.
If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. Mix spoons with other cutlery to prevent them from sticking together. For best results we recommend you use the cutlery grids. If the size and dimensions of the cutlery do not allow the use of the grids, they can be easily hidden or removed. Glasses with long stems can be placed upside down in the cup racks.
For glasses with long stems (according to the size and dimensions), set the glass holder to the left or right position. Maximum height of the dishes in the lower basket With upper basket raised 31 cm With upper basket lowered 27 cm To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. The central rows of prongs can be easily lowered to improve loading flexibility.
Warning! After loading your machine always close the door, as an open door can be a hazard. Use of detergent Only use detergents specifically designed for use in dishwashers. Please observe the manufacturer’s dosing and storage recommendations as stated on the detergent packaging. Using no more than the correct amount of detergent contributes to reducing pollution. 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent 3.
Detergent tablets Detergent tablets from different manufacturers dissolve at different rates. For this reason, some detergent tablets do not attain their full cleaning power during short washing programmes. Therefore, please use long washing programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Multi tab function This appliance is equipped with the Multi tab function, that allows the use of combi detergent tablets.
If the drying results are not satisfactory we suggest that you: 1. Fill up the rinse aid dispenser with rinse aid. 2. Activate the rinse aid dispenser. 3. Set the rinse aid dosage to position 2. • The activation/deactivation of the rinse aid dispenser is only possible with the Multi tab function active. rinse aid dispenser deactivated rinse aid dispenser activated 4. To change the setting, press function button B again, the digital display shows the new setting 5.
• Cancelling a delay start involves also the cancelling of the washing programme set. In this case you have to set the washing programme again. • If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. dishwasher door, the programme starts automatically. Once the washing programme has started, a point-shaped optical signal appears on the floor beneath the dishwasher door.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Unloading the dishwasher • Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. • Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance.
flat filter does not protrude above the base of the washing compartment. NEVER use the dishwasher without filters. Incorrect repositioning and fitting of the filters will produce poor washing results and will result in damage to the appliance. NEVER try to remove the spray arms. If residues of soil have clogged the holes in the spray arms, remove the debris with a cocktail stick. 4. Take hold of the coarse filter (A) by the handle with the hole and remove from the microfilter (B). 5.
1. Unplug it. 2. Turn the water tap off. 3. Remove the water inlet and discharge hoses. 4. Pull the machine out together with the hoses. Avoid over tilting the machine during transportation. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house, etc...
Fault code and malfunction Possible cause and solution • appears in the digital display • Intermittent audible signal • Point-shaped optical signal is flashing Anti-flood device is activated • Close the water tap and contact our extended warranty administrators, refer to Repairs-After Sales Service on the following pages. Malfunction Possible cause and solution The programme does not start • The dishwasher door has not been properly closed. Close the door. • The main plug is not plugged in.
The wash results are not satisfactory There are streaks, milky spots or a • Decrease rinse aid dosage. bluish coating on glasses and dishes Water drops have dried onto glasses and dishes • Increase rinse aid dosage. • The detergent may be the cause. Contact the detergent manufacturer’s consumer care line.
Technical data Dimensions Width Height Depth 60 cm 85 cm 60 cm Electrical connection - Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door. Water supply pressure Minimum Maximum 0,05 MPa (0,5 bar) 0,8 MPa (8 bar) Capacity 12 place settings Installation Fitting under a counter Warning! It is dangerous to alter the specifications or attempt to modify this product in any way. This appliance is heavy.
Remove the machine’s worktop by unscrewing the two rear retaining screws (1), pull the worktop from the back of the machine (2) and slide out the front slots, lifting the worktop (3). Insert the machine after adjusting the levelling with the adjustable feet. When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed. During all operations that involve accessibility to internal components the dishwasher has to be unplugged.
The water inlet hose must not be kinked, crushed, or entangled when it is being connected. The appliance features inlet and drain hoses which can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks. (Attention! NOT all models of dishwashers have inlet and drain hoses provided with a locknut.
When connecting the drain hose to an under sink trap spigot, the entire plastic membrane (A) must be removed. Failure to remove all the membrane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot. Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. If the spigot of your sink has a "no return valve" incorporated this can prevent the correct draining of your dishwasher.
Electrical connection Warning! Safety standards require the appliance to be earthed. Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed. The fuse rating is also to be found on the rating plate. Always plug the mains plug into a correctly installed shockproof socket. Multi-way plugs, connectors and extension cables must not be used.
4. The purchase date (found on your receipt). 5. The model and serial number of the appliance (found on the rating plate). So that you always have these numbers at hand, we recommend that you make a note of them here: Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . S.No. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
John Lewis Partnership 171 Victoria Street London SW1E 5NN www. johnlewis.
