User manual

Problem Possible cause Solution
The compressor operates continu-
ally.
Temperature is set incorrectly. Refer to "Operation" chapter.
Many food products were put in
at the same time.
Wait some hours and then check the
temperature again.
The room temperature is too
high.
Refer to climate class chart on the rat-
ing plate.
Food products placed in the ap-
pliance were too warm.
Allow food products to cool to room
temperature before storing.
The door is not closed correctly. Refer to "Closing the door".
The FastFreeze function is
switched on.
Refer to "FastFreeze function".
The compressor does not start im-
mediately after pressing the Fast-
Freeze, or after changing the tem-
perature.
This is normal, no error has oc-
curred.
The compressor starts after a period
of time.
Water flows on the rear plate of
the wine cooler .
During the automatic defrosting
process, frost melts on the rear
plate.
This is correct.
Temperature cannot be set. The FastFreeze or IntensiveCool-
ing function is switched on.
Switch off FastFreeze or Intensive-
Cooling manually, or wait until the
function resets automatically to set
the temperature. Refer to "FastFreeze
or IntensiveCooling function".
dEMo appears on the display. The appliance is in demonstration
mode.
Keep the Functions button pressed
for approximately 10 seconds until a
long sound is heard and display shuts
off for a short time.
Door is misaligned or interferes
with ventilation grill.
The appliance is not levelled. Refer to "Levelling".
The temperature in the wine cooler
compartment too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food products' temperature
is too high.
Let the food products temperature
decrease to room temperature be-
fore storage.
Many food products are stored at
the same time.
Store less food products at the same
time.
Wine Cellar Freezer User Manual 17