User manual

Problem Possible cause Solution
Water flows into the
refrigerator.
The water outlet is clogged. Clean the water outlet.
Food prevent that water flows
into the water collector.
Make sure that food do not touch
the rear plate.
Water flows on the
ground.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Attach the melting water outlet to
the evaporative tray.
There is too much frost
and ice.
Food are not wrapped properly. Wrap the food better.
The door is not closed correctly. Refer to "Closing the door".
The Temperature regulator may
be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too low.
The Temperature regulator may
be set incorrectly.
Set a higher temperature.
The temperature in the
appliance is too high.
The Temperature regulator may
be set incorrectly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food temperature is too
high.
Let the food temperature
decrease to room temperature
before storage.
The temperature in the
refrigeration is too high.
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance.
Large quantities of food to be
cooled were put in at the same
time.
Insert smaller quantities of food to
be cooled at the same time.
The appliance does not
operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected
to the mains socket correctly.
Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
Connect a another electrical
appliance to the mains socket.
Check fuse. Contact a qualified
electrician.
The lamp does not
work.
The lamp is in stand-by. Close and open the door.
The door has been open to long. Close the door.
The lamp is defective. Refer to "Replacing the lamp".
13