Technical Specifications

Vented Nailboard
®
Polyisocyanurate Nailable Roof Insulation®
Installation/Application
Mechanically
Fastened
Urethane
Adhesive
Hot Asphalt
• All Vented Nailboards must be mechanically attached.
• Install Vented Nailboard wood-side up.
• See following page for vent pattern.
• Refer to the application instructions guidelines for proper
utilization of this product.
Packaging and Dimensions
Foam Size 4' x 8' (1.22 m x 2.44 m)
Producing Locations
Hazleton, PA
Note: For available thicknesses, see Product Data and Packaging table on back side of this
data sheet. Contact your JM Sales Representative for details.
RS-5147 11-16 (Replaces 11-15)
Polyisocyanurate Insulation meets ASTM C 1289.
(available in 20 or 25 psi ENRGY 3)
Features and Components
Oriented Strand Board (OSB): Provides a strong nailable surface;
always install wood side up. Available wood thickness: OSB (7/16"
& 5/8"). All wood edges are routed 1/8" on all four sides to allow for
expansion and contraction of the wood.
Vent Strips: See pattern on next page. For wood thickness (1", 1.5", or 2").
ENRGY 3: Closed cell Polyisocyanurate foam core bonded inline to
glass reinforced facers (See ENRGY 3 data sheet), Vented Nailboard
is assembled offline using staples (strip to wood attachment) and
adhesives (strip-to-foam attachment).
OSB
Wood
Vent Strips
Closed Cell Polyisocyanurate
Foam Core
Glass-Reinforced
Facers
1/8”
Routed Edges
System Compatibility This product may be used as a component in the following systems. Please reference product application for specific installation methods and information.
Multi-Ply
BUR APP SBS
Single Ply
TPO PVC EPDM
HA CA CA HW HA CA HW SA MF FA MF FA MF FA BA
Do not use in Multi-Ply systems Compatible with the selected Single Ply systems above
Key: HA = Hot Applied CA = Cold Applied HW = Heat Weldable SA = Self Adhered MF = Mechanically Fastened FA = Fully Adhered BA = Ballasted
Component
Type
HT
High Thermal
CP
Composite
I
Insulation
Multi-Ply
Single Ply
Energy and the Environment
LEED
®
Recycled Content
Varies with thickness, see Product Data
and Packaging table on back page.
Produced with environmentally compliant pentane blowing agent with
zero ozone depletion (conforms to the Montreal Protocol of 1987).
Peak Advantage
®
Guarantee Information
Systems
Contact guarantee services regarding system warranty availability.
Codes and Approvals
• Incorporates APA/TECO Rating Sheathing Exposure 1 OSB
• Complies with EPA requirements and meets Clean Air Act
Amendments of 1990.
• Third-party certification with the PIMA Quality Mark
™
for Long-Term
Thermal Resistance (LTTR) values.
• UL Listed: refer to UL Directory of products.
Note: Technical information on this data sheet is intended to be used as a general
guideline only and is subject to change without notice. Contact your JM Sales
Representative for further details.
Refer to the Safe for Use instructions and product label prior to using this product.
The Safe for Use instructions are available by calling [phone] or on the Web
at www.jm.com/roofing.