Use and Care Manual

English--- 2
545154659 Rev. 10 3/15/12
CONTENTS
Contents
Introduction 2...................
Key to symbols 3..................
Safety instructions 4...............
Description 6.....................
Fuel handling 11....................
Starting and stopping 12............
Using the blower 13.................
Maintenance 16....................
Technical data 19...................
Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any nonroad engine re-
pair establishment or individual.
The Emissions Compliance Period referred
to on the Emissions Compliance label indi-
cates the number of operating hours for
which the engine has been shown to meet
Federal emissions requirements.
Category C = 50 hours, B= 125 hours, and
A = 300 hours.
For reference, please fill out the following
information that will be needed for future
servicing of your blower:
Model Number:
Serial Number:
Purchase Date:
Purchased From:
WARNING: Under no circum-
stances may the design of the
machine be modified without the
permission of the manufacturer.
Always use genuine accessories.
Non--authorized modifications
and/or accessories can result
in serious personal injury or the
death of the operator or others.
Your warranty may not cover
damage or liability caused by the
use of non--authorized accesso-
ries or replacement parts.
Note the following before start-
ing:
Jonsered has a policy of continuous product
development and therefore reserves the right
to modify the design and appearance
of products without prior notice. Long--term
exposure to noise can result in permanent
hearing impairment. Always use approved
hearing protection.
This operator’s manual describes in detail how
to use and service the blower and how
to carry out regular maintenance. It also de-
scribes which measures should be taken to
achieve maximum safety while operating the
blower, how the safety devices work and how
they should be serviced.
Note! The section of the manual that deals
with safety, must be read and understood by
all persons who come in contact with the
blower.
This operator’s manual has been written for
those who need guidance when it comes to
fault tracing, thorough servicing and carrying
out corrective maintenance of the blower .
There are warn ing symbol s on the blower .
Should any of the warning symbols on the
blower become disfigured or worn, new ones
should be ordered and fitted to the blower as
soon as possible. Note that some of the warn-
ingsymbolsmaybemoldedincertaincompo-
nents of the blower.
The blower is used
f
or bl owin g away leaves
and other debris on the ground. When op-
erating the blower, the operator must stand
with both feet firmly on the ground.
WARNING
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth d efects or other reproductive harm.