Use and Care Manual

Starting the Engine

1. Push key in (Figure 9).

2. Move choke lever to left position (Figure 10).

3. Firmly push in the primer 2 times with your thumb,

holding the primer in a for a second before releasing

it each time (Figure 11).

NOTE: Remove your glove when you push in the primer

so that air cannot escape from the primer hole.

IMPORTANT: It may not be necessary to use the primer

or the choke if the engine has been running and is hot.

Excessive priming may flood the engine and prevent it

from starting.

4. Pull the recoil starter (Figure 13) or if your snow thrower

is equipped with an electric starter, connect an exten-

sion cord to the snow thrower and plug the other end

into a three-hole grounded 110 volt A.C. receptacle

and push the electric-start button (Figure 12).

NOTE: Use an extension cord recommended for outdoor

use that is not longer than 50 feet (15 m).

1. Primer

Figure 11

Figure 9

1. Key

Figure 12

1. Electric start button

1. Choke lever

Figure 10