Use and Care Manual

The Tool Rest has a rotating MAIN
PLATE which has 2 sides/functions:
-One side helps set bevel angles on
square-edged Tools such as Chisels
-The other side helps you sharpen
Drill Bits to precise degrees.
TOOL REST - CHISEL SIDE
21
MULTIPLE FUNCTIONS
SETUP & SHARPEN COMMON CHISELS
Slide the Posts into the mounting
holes as shown. Spacers (”S”) provide
additional height if needed
(Late availability.)
Locking knob will be on left-hand
side when properly mounted.
Lock the Tool Rest in place by
tightening the post locking screws
(Turn Clockwise to lock)
LOCK
UNLOCK
UNLOCK MAIN PLATE BEFORE ROTATING
Turn knob counterclockwise to loosen,
but do NOT unscrew completely.
LOCK MAIN PLATE AFTER SETTING ANGLE
Turn knob clockwise to lock the position,
but do NOT overtighten.
Rotate the main PLATE to
set the desired angle by
aligning indicators on
RIGHT-HAND post with
the ANGLES indicator.
Lock with LOCKING KNOB
For precise & even angles,
slide the Guides to the
corresponding width of
your tool. Make sure the full
face to be sharpened is in
contact with the abrasive.
Tool must slide in/out freely.
Sharpen the Chisel by sliding
the cutting edge it into the
spinning disc. Use coarse grades
such as 3M Purple Ceramic for
regrinding a damaged edge.
Use ne grades (3M Trizact™)
for honing existing bevels.
Always make uniform contact
with the spinning abrasive. Use
coarse abrasives to re-grind
edges and ne abrasives to
polish (see p. 15). When done,
slide the Chisel away from the
disc and turn the JOOLTOOL OFF.
Toll Free: 1-85-JOOLTOOL p.12 Buy supplies at WWW.JOOLTOOL.COM
LEFT-HAND
POST
RIGHT-HAND
POST
MAIN PLATE
GUIDE(s)
LOCKING
KNOB
MODE ICON
SEE DEBURRING INFO ON NEXT PAGE
!
S
S
INSTALL THE TOOL REST
CHISEL / FLAT-BLADE SIDE
(UN)LOCKING THE PLATE