Use and Care Manual

STEP 1 SHAPE your clay
Use 3M Micronishing Film 15 Mic. (Orange/Translucent)
Hold the piece FLAT against the spinning abrasive.
Speed: Medium / Low Speed
1
STEP 2 REMOVE Scratches
Use 3M Micronishing Film 9 Mic. (Translucent abrasive)
Hold the piece FLAT against the spinning abrasive.
Speed: Low Speed
2
STEP 3 Rene the surface to produce a smooth satin nish
Use the FELT DISC WITH COMPOUND.
Make FLAT contact, then move piece to polish desired areas.
SPEED: Very Low Speed TIP: Higher speeds remove material!
The speed determines the amount of material that is polished off.
3
STEP 4 BUFF your clay
Use Bung Wheel with LIGHT PRESSURE!
DO NOT PUSH hard against the edge of the spinning Bu.
Speed: High Speed, Finish with Slow Speed.
DO NOT USE COMPOUND!
4
FOLLOW FROM
TOP TO BOTTOM
POLYMER CLAY & RESIN
FLAT OR DETAILED PIECES
HOW TO SHAPE & POLISH
Toll Free: 1-85-JOOLTOOL p.20 Buy supplies at WWW.JOOLTOOL.COM
STEP 1 SAND your clay
Use 3M Radial Brushes (Pumice -Pink)
Gently hold the pice against the outer EDGE of the brush.
Speed: High Speed
STEP 3 POLISH your clay
Use the Bung Wheel WITH COMPOUND
Use LIGHT PRESSURE! DO NOT PUSH HARD on bu.
Speed: High Speed
TIP: The speed affects the amount of
material that is polished off.
STEP 4 BUFF your clay
Use the CLEAN Bung Wheel WITHOUT COMPOUND
Use LIGHT PRESSURE! DO NOT PUSH HARD on bu.
Speed: High Speed
REMINDER: DO NOT USE COMPOUND FOR THIS STEP (4)!
STEP 2 PRE-POLISH (OPTIONAL)
Use 3M Radial Brushes (6 & 1 Micron - Peach and Green)
Hold the piece against the edge of the spinning brush.
Speed: High Speed
1
4
2
3
Apply CUSHIONS to BACKPADS.
FELT & BUFF don’t need cushions.
Apply abrasives onto BACKPADS
(with the CUSHIONS applied).
Prepare FELT DISC as shown in your
USER’S GUIDE and VIDEO
SETUP
!
SAFETY FIRST!
Always wear eye
and respiratory
protection.
1
2
3
IMPORTANT: Stay within your see-thru area of the disc. Avoid using the edge to prevent cutting grooves in the clay.
FINE 15 Mic
Item# AM-13015-6
1
FLAT PIECES
FOR DETAILED PIECES
VERY FINE 9 Mic
Item# AM-13009-3
2
FELT DISC
Item# B-301
3
BUFFING WHEEL
Item# B-9335
4
FOLLOW FROM
TOP TO BOTTOM
Pumice (pink)
Item# R-343-PUM
1
BUFFING WHEEL
Item# B-9335
3
BUFFING WHEEL
Item# B-9335
4
6 Micron
Item# R-342-6
2a
1 Micron
Item# R-341-1
2b
Use with COMPOUND
Item#: C-103
+
Use with COMPOUND
Item#: C-103
+
POLYMER CLAY ADD-ON KIT: Item# K-1005