Use and Care Manual

POLYMER CLAY & RESIN DOMED OR ROUNDED PIECES
HOW TO SHAPE & POLISH
Toll Free: 1-85-JOOLTOOL p.21 Buy supplies at WWW.JOOLTOOL.COM
NOTE: Abrasives shown are included in POLYMER CLAY UPGRADE KIT (Item# K-1005-5) and can be purchased at JOOLTOOL.COM
Apply FOAM CUSHIONS to BACKPADS.
BUFF does not require a cushion!
Apply ABRASIVES over FOAM CUSHIONS
applied to BACKPADS.
SETUP
!
SAFETY FIRST!
Always wear eye and
respiratory protection.
1
2
IMPORTANT: Do NOT use on pieces with sharp edges. This can increase risk of catching and tearing the abrasive
NOTE: For best results, make sure to work over the entire surface (or desired areas) for each step.
FOR DOMED OR ROUNDED PIECES ONLY!
STEP 1
REFINE the surface of your clay
Use 3M Micronishing Film abrasives
at VERY LOW SPEED.
Hold the piece against the spinning
abrasive with smooth, consistent pressure
in a CONTINUOUS CIRCULAR MOTION.
- Steps & grind faster, use them to
quickly smooth out bumpier surfaces.
- Steps & are ner, use them for
prepping the surface for a high polish.
1
STEP 2 POLISH your clay
Use the Bung Wheel WITH COMPOUND
Use LIGHT PRESSURE! DO NOT PUSH HARD.
Speed: High Speed
TIP: The speed affects the amount of
material that is polished off.
2
+
a
b
c
d
DONE!
Enjoy your polished Polymer Clay creation!
STEP 3 BUFF your clay
Use the CLEAN Bung Wheel WITHOUT COMPOUND
Use LIGHT PRESSURE! DO NOT PUSH HARD on bu.
Speed: High Speed
REMINDER: DO NOT USE COMPOUND FOR THIS STEP (3)!
3
FOLLOW FROM
TOP TO BOTTOM
BUFFING WHEEL
Item# B-9335
3
MICROFINISHING FILM
Item#s AM-13060-6
a
MICROFINISHING FILM
Item#s AM-13030-6
b
MICROFINISHING FILM
Item#s AM-13015-6
c
MICROFINISHING FILM
Item#s AM-13009-6
d
BUFFING WHEEL
Item# B-9335
2
Use with COMPOUND
Item#: C-103
+