Use and Care Manual

ABRASIVES
by
ALTERNATE POLISHING STEP
Some glass polishes easily with our FELT DISC
and our compound. Try this after step 1b.
Speed: High Speed. DO NOT USE WATER
REMOVE SCRATCHES & POLISH GLASS*
Toll Free: 1-85-JOOLTOOL p.22 Buy supplies at WWW.JOOLTOOL.COM
GLASS WATCH CRYSTAL
STEP 1 LIGHT BEVELING, SMALL CHIP REMOVAL
Follow these steps for scratch removal & pre-polishing
Use 3M Trizact abrasives, the colorful discs.
Speed: Medium with a lot of WATER
Follow this order:
Trizact Green Coarse
Trizact Pink Medium
Trizact Blue Fine
Trizact Orange Very Fine
STEP 2 POLISH your glass
Use 3M Cerium Oxide to get a nal polish
WARNING: Do NOT use on porous surfaces
Speed: SLOW with a lot of WATER
FOLLOW FROM
TOP TO BOTTOM
IMPORTANT: Stay within your see-thru area of the disc. Avoid using the edge to prevent cutting grooves in the glass.
ANIE’S TIP:
To avoid scratches on the nished piece, follow ALL steps THOROUGHLY and inspect your piece after each step.
ALTERNATE STEP
FELT DISC
Item# B-301
SOLD SEPARATELY
1
2
3
WATCH CRYSTAL POLISHING ADD-ON KIT: Item# K-1004
This 4-Grade Kit Item# K-3200-12
Apply COMPOUND on FELT DISC & BUFFING WHEEL
Item#: C-103
Coarse
Item# AT-13035-6
1a
Medium
Item# AT-13020-6
1b
Fine
Item# AT-13010-6
1c
Very Fine
Item# AT-13005-6
1d
FINAL STEP:
Cerium Oxide
Item# AT-13000-2
2
Apply CUSHIONS to BACKPADS.
FELT & BUFF don’t need cushions.
Apply abrasives onto BACKPADS
(with the CUSHIONS applied).
Use Water Tray to apply water to the
workpiece during every step.
SETUP
!
SAFETY FIRST!
Always wear eye
and respiratory
protection.
1
2
3
FOR DOMED OR FLAT GLASS
* Except Mineral Crystal