Use and Care Manual

Toll Free: 1-85-JOOLTOOL p.24 Buy supplies at WWW.JOOLTOOL.COM
QUICK-MOUNT FLEXSHAFT
INSTALL BITS (Type 30 Handpiece) USE
USE
Insert the desired bit
into the handpiece
chuck/jaw. Note: Jaw
must be opened wide
enough to t your bit.
Using the chuck key,
tighten the jaw.
Note: Check if the bit
is centered by rotating
the chuck by hand.
Use small brushes for
intricate sanding and
polishing in hard-to-reach
areas. Use Diamond &
Drilling bits on a variety of
materials, even stones!
1 2
a
b
INSTALL BITS (Type 20 Handpiece)
Position the locking
lever perpendicular to
Handpiece. This opens
the chuck.
a) Insert the desired bit
b) reset the lever
in-line with Handpiece
to close & lock.
1
Insert & screw on the
collet nut but do NOT
tighten yet.
Insert desired Bit into
Collet. Tighten Collet
with the Wrench.
Use small brushes for
intricate sanding and
polishing in hard-to-reach
areas. Use 2” or 3”
brushes for nishing work
on larger projects.
4
a
b
INSTALL BITS (Type 44 Handpiece)
Insert pin into the
Handpiece. Unscrew
& remove the collet
nut. Use wrench if
needed.
Insert the desired
collet into mandrel.
Note: Collet size must
match shaft size of bit.
1 2
INSTALL/CHANGE A HANDPIECEINSTALL THE FLEXSHAFT
Slide the Flexshaft Connector
Hub onto the Jooltool spindle.
This is similar to installing
Backpads onto the Spindle.
1
Tighten the connector Hub
rmly onto the JOOLTOOL
spindle.
2
a: Insert the Flexshaft’s Paddle
(Key) Tip into Handpiece until
it snaps & locks in place.
b: To remove: Pull apart
1
a
b
Once installed, test run the
JOOLTOOL at various speeds.
Rotation should be smooth.
If vibration occurs, turn
JOOLTOOL o and re-install.
2
3
Pin
Pin
Remove
Pin
HOW TO SETUP AND USE
(some items below may be sold separately)
Item# J-20
Item# J-30 or J-30H
Item# J-44
FOR SAFETY: POWER “OFF” BEFORE INSTALLING FLEXSHAFT AND/OR ACCESSORIES
!
REMOVE PIN
BEFORE USE!
!
a
a
b
b
a
b
2