Operation Manual

19
Thread the guide
A
and then
thread the thread guide (guide in
the circle) for bobbin winding
1
Place the thread spool to the spool
pin.
2
Winding the bobbin thread
* An exclusive motor is built-in for winding
bobbin so that you can wind bobbin at any
time.
Set the bobbin on the bobbin winding
shaft.
3
4
Wind the thread to the bobbin 4-5 times in
clockwise direction.
Put the thread end into the guide at the
bobbin winding shaft and pull it to the
right side to cut it.
5
7
Push the bobbin winding regulator
towards the bobbin to start winding the
bobbin.
* Be careful that the bobbin winding regulator
works as a switch.
6
When winding is nished, the shaft
stops automatically, the bobbin winding
regulator moves to right and return to the
original position.
Remove the bobbin from the bobbin
winding shaft and cut the thread by cutter.
* Bobbin winding will automatically stop even
while winding, when the winding speed is re-
duced due to a load to the bobbin winding motor
caused by thread tangling.
Bobbin winding regulator
Guide (with cutter)
Spool
pin
Cutter
Thread guide
Bobbin
winding shaft
A