Operation Manual

37
Straight stitch
Sewing start
Pull the needle and bobbin threads under the presser
foot to the rear of the machine and lower the presser
foot to start sewing.
Sewing end
Stop sewing and push the thread trimming button to trim
the threads.
<by thread trimming button>
When you push the thread trimming button, the thread is
trimmed and the presser foot automatically goes up.
You can also set the function to lift the presser foot after
thread trimming to OFF.
(Refer to page 93 )
<by foot controller>
* You can also cut the threads by the thread cutter at
the face plate cover.
Pattern No. Direct 1
Presser foot
Standard presser
foot (A)
Thread tension Auto
Attention
Turn OFF the power switch
before replacing the presser
foot.
This means presser foot is up.
Lower the presser foot to start
sewing.
Foot switch function
It is possible to set so that the thread is trimmed by
depressing the front section of the foot controller.
(Refer to page 89 )