Operation Manual

50
Groove
Button holder
1
Set the presser foot.
Lift the needle and lift the presser foot.
Align the groove of the presser foot holder with the pin
of the presser foot and lower the presser foot holder to
set.
2
Set the button.
Pull the button holder toward
A
, place the button on
the button holder, and then push the holder toward
B
to set the buttonhole length.
* It is impossible to set a button thicker than
4mm.
Pin
A
B
3
Set the buttonhole sensor pin.
Insert the sensor pin into the sensor pin hole at the
face plate cover.
* Insert the pin into the hole completely.
*
I
f the machine starts to sew without inserting
the pin into the hole, the following message will
be shown on the display.
Set the sensor pin
and restart.
Sensor pin
* Check the following
points after setting the
presser foot and then
start to sew buttonholes.
Check that there
is a clearance.
If there is not a
clearance, the
machine will
not sew neat
stitches.