Operation Manual

52
Eyelet
punch
It will be easier to sew buttonholes on the thin fabrics
and/or near the overlapped sections, if the clamping
plate is used.
Clamping plate
1. Attach the buttonhole presser foot
to the presser foot holder, with the
clamping plate together.
2. Place the fabric between the presser
foot and the clamping plate.
* You can remove the clamping plate by holding
A
.
● Buttonhole clamping plate
Stopper
pin
6
Unplug the sensor pin after sewing.
7
Opening the buttonhole using a ripper.
[double bartack]
Pierce a stopper pin at the bartack and open the but-
tonhole with a ripper. Be careful not to cut the stitches.
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a
hole with the eyelet punch. Then pierce a stopper pin
at the bartack and open the buttonhole with a ripper.
Ripper
A
Turn off the power when
setting the clamping plate.
Caution