Instructions / Assembly

5. Look under the trampoline and locate the pairs of

straps attached to the underside of the Frame Pad

(6). Note that some pairs of straps are near the

frame and other pairs of straps are near the edge

of the Bed (5). Position each outer pair of straps

so one strap is on each side of the frame as

shown. Position each inner pair of straps so one

strap is on each side of the nearest Spring (4) as

shown.

See the inset drawing.

Do not overtighten the straps.

Repeat this step with the remaining straps (not

shown).

Strap with “S” hook on the pad edge

Cross the strap over the toprail frame to hook the V ring

6. Thread one end of Elastic Tie-Down, then tie a knot

on V-Ring.

Repeat this step with the remaining straps which at

middle position of each pad section (not shown).



Elastic Tie-Down

Spring

V-Ring



T-connector (2)

Frame pad (6)

Adjustable handle frame opening



7. Lay two bottom poles (7), and one arch pole (8)

on the ground.

Insert the foam sleeve cover(13) into bottom poles(7)

and arch pole(8) to protect the foam.

Make sure that the bottom pole (7) is oriented

so the small holes are in the position shown.

Slide a Foam Sleeve (12) onto each of the tubes;

note that the ends of the bottom pole (7) should

not be covered.

Connect the bottom pole (7) to arch pole (8) by the clip.

Joint the end of each pole by Clip of Connector