Instructions / Assembly

Important: The frame is held together under
tension so you will have to use some force to
insert certain parts.
Place your feet on the top tubes and grip the leg
extension with both hands.
Pull the extension until it can be slotted into the
T-connector+Welded tube.
Slot the end of leg extension into th
+ welded tube.
e T-connector
17
Insert the Center leg and L leg into upright tube
ton T-connector + welded tube.
Note: You may need to tap the leg extension in
using a rubber mallet or by placing a piece of
wood over the top of the tube. Do not use a metal
hammer on the metal tube as this may distort the
end of tube.
STEP 1 : ASSEMBLING THE FRAME
You will need the following parts to complete
section 1a:
2 x L-Top tube with Welded connector
- Part A
2 x L-Top tube with Welded connector
- Part F
beut poT x 4
- Part B
e with welded tubebut poT x 2
- Part C
ebut poT x 2
- Part D
ebut poT x 2
- Part G
e with welded tubebut poT x 2
- Part E
8 x L Leg
- Part H
4 x Centre legs - Part I
A
A
G
B
B
B
C
C
E
D
D
E
F
G
F
H
H
H
H
H
I
I
I
L-Top tube
A marking
Centre leg
L-Top tube
F marking
L Leg
16 x Self tapping screws & washers - - Part Q
You will also need a cross-head screwdriver
(not
supplied)
.
Self tapping screw and washer
Cross-head screwdriver
Top tube B marking
Top tube C marking
Top tube D marking
Top tube E marking
Top tube G marking