User manual

WARNING! Do not put water
directly into the steam
generator!
Use only water as the liquid. Do
not use filtered (demineralised)
or distilled water.
1. Press the cover of the water drawer to
open it.
2. Fill the water drawer with 800 ml of
water.
The water supply is sufficient for
approximately 50 minutes.
3.
Push the water drawer to its initial
position.
4.
Activate the appliance.
5.
Set the steam function (refer to the
"Oven functions" table) and the
temperature.
6.
If necessary, touch
to set the
DURATION or END function (refer
to "Setting the END" or "Setting the
DURATION").
The first steam shows after approximately 2
minutes. An acoustic signal sounds when
the appliance is at approximately the set
temperature. The signal sounds again at
the end of the cooking time.
7. Touch
to deactivate the acoustic
signal and the appliance.
When the steam generator is
empty, an acoustic signal
sounds.
When the appliance cools down, soak up
all remaining water from the steam
generator with the sponge. If necessary,
clean the steam generator with some
vinegar. Let the appliance dry fully with the
door open.
CLOCK FUNCTIONS
Clock functions table
Clock function Application
TIME OF DAY To show or change the time of day. You can change the
time of day only when the appliance is on.
DURATION To set how long the appliance operates.
END To set when the appliance deactivates.
TIME DELAY To combine DURATION and END function.
SET+GO To start the appliance with necessary settings with only one
touch of the sensor field any time later.
MINUTE MINDER To set a countdown time. This function has no effect on the
operation of the oven. You can set the MINUTE MINDER at
any time and also when the appliance is off.
00:00
COUNT UP TIMER To set the count up, which shows how long the appliance
operates. This function has no effect on the operation of the
appliance. It is on immediately when the oven starts to heat.
The COUNT UP TIMER is not activated if DURATION and
END are set.
12