User manual

Problem Possible cause Remedy
The lamp does not operate. The lamp is defective. Replace the lamp.
The display does not show
the time during the off status.
The display is deactivated.
Touch and at the
same time to activate the dis-
play again.
The core temperature sensor
does not operate.
The plug of the core temper-
ature sensor is not correctly
installed into the socket.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.
It takes too long to cook the
dishes or they cook too
quickly.
The temperature is too low or
too high.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Steam and condensation set-
tle on the food and in the
cavity of the oven.
You left the dish in the oven
for too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
The display shows "C2". You want to start the Defrost
function, but you did not re-
move the core temperature
sensor plug from the socket.
Remove the core tempera-
ture sensor plug from the
socket.
The display shows an error
code that is not in this table.
There is an electrical fault. • Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
43