iCharger 4010DUO Battery Charger Manual

ManualsBrandsJunsi ManualsBattery ChargersICharger 4010DUO Multi-Chemistry DC Battery Charger (10S/40A/2000W)

iCharger

iCharger Synchronous

Synchronous

Synchronous Balance

Balance

Balance Charger/Discharger

Charger/Discharger

Charger/Discharger 4010DUO

4010DUO

- 21 -

② Beep

Beep

Beep Tone

Tone

Tone Setup

Setup

Select

SYSTEM MENU → Charger Setup → Beep Tone to

enter the setup interface.

Note: Tick the appropriate tone, and then go to Volume adjustment bar of tones to adjust the volume;

If the beep tone failed to tick the corresponding volume adjustment it shows inactive;

Done

Beeps

are many styles available, as shown above.

③ LCD

LCD

LCD Setup

Setup

Select

SYSTEM MENU → Charger Setup → LCD Screen

to enter the setup interface .

④ Output

Output

Output Power

Power

Power Setup

Setup

Select

SYSTEM MENU → Charger Setup → Output Power to

enter the setup interface.

Note: The maximum power limit for regenerative discharge is equal to the maximum power limit for

charge.

When the input or output power of charger is limited, it will trigger the CH-1/CH-2 Channel

Partiality.

When Partiality switches to

Same

, charger assigns averagely the output power to two

channels,switch to CH-1 or CH-2, the charger will give priority to the selected channel output

power,while the output power of other channel may be reduced to 50W (discharge for 5W).

Beep Tone Setup

1: V olume adjustment display

2: Program Done Beep Tones S elect ion

Beep 5times (default))

Beep 30second

Beep always

Beep 3minutes

LCD Setting Interface

1: Brightness adjustment

2: Contrast adjustment

1/2 : CH-1/CH-2 Output Power Setup

Charge : Maximum Power Limit for charge

5W-1400W; default: 1400W

Discharge : Maximum Power Limit for discharge

5W-130W ; default : 130W

3 : CH-1/CH-2 Channel Partiality Select ion

Same (default), CH-1, CH-2