iCharger 4010DUO Battery Charger Manual

iCharger
iCharger
iCharger
iCharger Synchronous
Synchronous
Synchronous
Synchronous Balance
Balance
Balance
Balance Charger/Discharger
Charger/Discharger
Charger/Discharger
Charger/Discharger 4010DUO
4010DUO
4010DUO
4010DUO
- 8 -
iCharger
iCharger
iCharger
iCharger Charge/Discharge
Charge/Discharge
Charge/Discharge
Charge/Discharge Setup
Setup
Setup
Setup &
&
&
& Use
Use
Use
Use
4010DUO iCharger can charge/discharge LiPo, Lilo, LiFe, NiHM, NiCd , Pb batteries, this manual divides into three
parts to introduce features and use for LiXX, NiXX, Pb batteries.
●
●
●
● Power
Power
Power
Power Supply
Supply
Supply
Supply Setup
Setup
Setup
Setup
The charger boots automatically when power on and the initial interface will display LOGO, charger relevant
information, power source and message etc.
System will delay 5S
5S
5S
5S after booting, during this period, press TAB
TAB
TAB
TAB /
/
/
/ SYS
SYS
SYS
SYS button to change the input source type, while
press any other buttons to enter the initial interface.
Note : Set type of input power supply in SYSTEM MENU → Charger Setup → Power Supply ; see details in
Page20 4010DUO
4010DUO
4010DUO
4010DUO Parameters
Parameters
Parameters
Parameters Setup
Setup
Setup
Setup .
After selecting the input power supply, confirm and enter the initial interface .
Note: The specific display of each region can refer to the introduction in Page10 & Page11 Program
Program
Program
Program
Running
Running
Running
Running Status
Status
Status
Status & Error
Error
Error
Error Messages
Messages
Messages
Messages .
Booting I nterface
1: Logo 2: Model
3: Version 4: Series number
5: Input power voltage
6: Input power source
7: Hint message
1
2
4
3
5
7
6
1
3
2
Initial I nterface
1: CH-1Channel I nfo rmation D isplay
2: CH-2Channel I nfo rmation D isplay
3: Status D isplay