DC Battery Charger Manual
X8
Mini Balance Charger/Discharger/DC Power
- 10 -
character, <> to delete the character. Press <> after editing program name to finish. If the program name is
empty, the system will name it automatically.
2. If the Editing program is the built-in program, the program name and battery type etc. parameters cannot be
changed.
After setting the basic parameters of a battery, click " " to enter MEMORY OPTION interface, after setting click
“ ” to return to MEMORY SETUP.
Note: If tick Auto saves before the program runs, the parameters set on the Run program will be saved
automatically, and the Run Program will display “Auto save” ( shown in the following left picture), otherwise it
will display “Don’t save!” (shown in the following right picture);
Run Program for Charger
After selecting program on MEMORY SELECTION, click to enter Run Program interface (press <> on the initial
interface will enter Run Program from the last running program), as below:
Note: 1. The revised common parameters of built-in program will be saved by default automatically after running,
while the program customized by the user can be set to be saved or not in MEMORY SETUP→MEMORY
OPTION→Auto save before the program runs.
2. After setting the Cap. value, when the Current value exceeds the certain value, the system will show a
warning and alarm. The Current value of each battery type is: LiXX battery :> 3C, NiMH/NiCd battery :>
2C, Pb battery :> 0.3C, NiZn battery>2C.
3. Press <> or <> to choose “ Run Program”, the common parameters are in grey, which is inalterable; if
needs to change, the user can press <>, as below:
1: Run Program Selection
2: Common Parameters Setup
3. Auto- save Hint
Auto save before the program runs: if ticking, the modified
parameters will be saved automatically; default: ticking
Run Counter: 0-999; default: 0
Log Interval: 0.5-60Sec; default: 1Sec
Log save to SD card: if ticking, the Log will be saved
to SD card
1
3
2