DC Battery Charger Manual

Mini Balance Charger/Discharger/DC Power

- 16 -

Switch to Balance charge mode on Chg Mode, and click “ ” behind Chg End Current to enter CHARGE

BALANCE End SETUP interface for setting.

LiPo/LiIo/LiFe/LiHV/LTO Battery Charge Advanced Setup

Click " " to enter LiPo/LiIo/LiFe/LiHV/LTO ADVANCED SETUP, after setting, click" "to return to the

previous interface.

Note: 1. When charging the over-discharged battery, the charger will detect if the cell voltage is larger than the restore

voltage, if larger, it will pre-charge the battery with restore current, if within the setting restore time, the cell

voltage rises to the normal value then it will turn to the charging program; otherwise it will stop running.

2. After charging, the battery may not be completely charged; tick Keep charging after the done to charge the

battery with smaller current when charging ends.

LiPo/LiIo/LiFe/LiHV/LTO Battery Charge Safety Setup

Click " " to enter CHARGE SAFETY SETUP, after setting click" " to return to the previous interface.

Note: Cut-Temp. is the maximum safety temperature of the battery. If the temperature sensor detects the set value,

the program will stop running in order to protect the battery from being damaged by high temperature.

LiPo/LiIo/LiFe/LiHV/LTO Battery Storage Setup

This mode is for storing LiPo/LiIo/LiFe/LiHV/LTO battery that will not to be used for a long time. The charger

determines whether to charge or discharge the battery based on the configured target voltage. If the battery voltage

exceeds the target storage voltage, it will start to discharge, while lower than the target storage voltage, it will start to

charge.

Cut-Temp: 20℃-80℃; default: 45℃

Max Capacity: 50%-200%; default: 120%

Safety Timer: 1Min-9999Min; default: off

1: The charger will stop balance charge if detects the

Balance condition is met, and the End Current

condition is invalid

2: The charger will stop balance charge if detects the End

Current condition is met, and the Balance condition is

invalid

3: The charger will stop balance charge if detects the End

Current condition or the Balance condition is met

4: The charger will stop balance charge if detects the End

Current condition and the Balance condition are met

Restore Lowest Voltage:

0.5V/Cell-2.5V/Cell; Default: 1V/Cell

Restore Charge Time:

1Min-5Min; default: 3Min

Restore Charge Current:

0.02A-0.5A; default: 0.1A