DC Battery Charger Manual

X8
Mini Balance Charger/Discharger/DC Power
- 18 -
LiPo/LiIo/LiFe/LiHV/LTO Battery Cycle Setup
Select Program→Cycle to enter Cycle setup interface, after setting click" " to return to the previous interface.
LiPo/LiIo/LiFe/LiHV/LTO Battery Only Balance Feature
Select Program→Balance Only to enter Balance Only setup interface, after setting click" " to return to the previous
interface.
Note: Balance Only is the program only to equalize the individual cells through balance port to reduce the voltage
difference.
NiMH/NiCd Battery Charge/Discharge Setup
After adding a program, it will switch to NiMH/NiCd battery in Type option on the MEMORY SETUP interface. Set the
Capacity, the number of Cells for NiMH/NiCd battery cannot be set, and the charger sets Auto by default, after editing
all parameters for the program, click" " to save and return to the previous interface.
As shown in above picture, the program of NiMH, NiCd has the following modes: Charge, Discharge and Cycle.
Cycle Mode:
CHG → DCHG(default),DCHG → CHG ，
CHG → DCHG CHG, DCHG → CHG DCHG,
CHG → DCHG STO, DCHG → CHG STO
Cycle Count:
1-99; default: 3
Delay Time:
0Min-9999Min; default: 3Min
Cut-Temp: 20℃-80℃; default: 45℃
Max Capacity: 50%-200%; default: 90%
Safety Timer: 1Min-9999Min; default: off